Filter
Top Products
9
4. Remove the power cord from the Spa Jet Unit (13).
With the help of a second person, place the Spa Jet
Unit (13) over the Side Panel (1) and the section of
the Inflatable Spa Liner (9) which does not have the
cushion. Be extremely careful not to tear the
Inflatable Spa Liner (9) as you slide the Spa Jet
Unit into place.
5. Before you fill the hydrotherapy spa, be sure that it
is in the position you want, and that it can be easily
serviced, if needed. Once the hydrotherapy spa is
filled with water, it will need to be drained to be
moved.
Using a garden hose or other clean water source,
begin filling the hydrotherapy spa, until the jet and
filter openings on the Spa Jet Unit (13) are covered
with water. Do not fill the RENEW 800 more than
20Ó deep with water.
After the RENEW 800 is full, you must prime the
Spa Jet Unit (13) before using the hydrotherapy
spa (see PRIMING THE SPA JET UNIT on page
10).
6. Insert the Support Ball (4) into the mesh pocket on
the underside of the Spa Cover (11).
See inset drawing A. Insert the inflation tube into
the hole in the Support Ball (4). Inflate the Support
Ball.
See inset drawing B. When the Support Ball (4) is
inflated, remove the inflation tube from the Support
Ball and insert the ball plug through the mesh into
the Support Ball. The head of the ball plug will
hold the Support Ball in place.
Note: The Support Ball (4) is not a toy.
4
5
1
9
13
13
9
Power
Cord
BA
11
Mesh Pocket
4
4
Inflation
Tube
Ball
Plug
4
6