Filter
Top Products
12
SPA JET UNIT OPERATION
The spa jet unit features three hydro-therapy jets, a
whirlpool jet, a suction vent, and a filter housing.
The three hydro-therapy jets (A), located on the
front of the spa jet unit, focus the water massage on
your neck and back.
The whirlpool jet (B), located on the left side of the
spa jet unit, directs the flow of the water to create a
whirlpool action in the hydrotherapy spa.
The suction vent (C),
located on the right
side of the spa jet unit,
pulls the water into the
spa unit, in order to
operate the system.
The suction cover
should always be in
place over the suction
vent. Never operate
the spa without the
suction cover in
place.
The filter (D), is locat-
ed on the left side of
the spa jet unit, behind
the filter cover. The fil-
ter can be removed for
cleaning and replace-
A
B
D
C
C
USING THE CONSOLE
Refer to the console diagram above. The function of
each console control is explained below:
Primer: This opening allows you to prime the spa jet
unit before operation (see PRIMING THE SPA JET
UNIT on page 10).
Air Control: Determines the amount of air that is in
the spa jet system during operation. If the control is
turned to the left, the amount of air flowing through
the jets will increase. If the control is turned to the
right, the amount will decrease.
Thermostat: Controls the temperature of the water.
The water heats at about 1.7¡F an hour with the cover
on. The thermostat can be set to heat the water from
70¡F to 104¡F. Use a medical or other accurate ther-
mometer to check the temperature of the water.
On/Off: Turns the spa jet unit on and off. When you
first press the on/off button, the spa jet unit will run at
low speed, providing gentle hydrotherapy. Press the
button again and the jet unit will run at high speed,
providing more intense hydrotherapy. Press the button
a third time and the spa jet unit will shut off.
The spa jet unit also features an automatic mode,
which heats and filters the water when the spa is left
unattended. When the spa jet unit is first plugged in,
or if the buttons on the console have not been used
for longer than twenty minutes, the automatic mode
will begin filtering or heating the water, as needed.
Note: to keep the filter and heat cycles from run-
ning, the power cord must be unplugged.
DIAGRAM OF THE CONSOLE
Filter Cover
Screws
Filter Cover
D