Filter
Top Products
9
3. Refer to the inset drawing. Set a Filter Gasket (33)
on top of the Filter (16). Next, press the Filter Cover
(8) into the spa until it is fully seated. Then, tighten
the Locking Ring (19) onto the spa.
Remove the two warning decals (not shown) from
the spa shell. Using a damp cloth, wipe the spa shell
clean. Before filling the spa, make sure that it is
in the desired position and that there is room to
easily service the spa. Once the spa is filled, it
will have to be drained before it can be moved.
Turn the Air Vent (29) counterclockwise to open
it. Using a garden hose or other clean water source,
begin filling spa. Do not use soft water. The spa
may be filled with cold water; however, if warm or
hot water is used, the spa will be ready for use
sooner. Fill the spa until the water is at the level
shown at the right. Do not overfill the spa.
Turn the Air Vent (29) clockwise to close it.
4. Attach the nozzle of the included air pump to the
valves on the Inflatable Cover (4). Fill the Inflatable
Cover with air. Do not overfill the Inflatable Cover.
Slide one of the straps on the inside of the Spa
Cover (11) through one of the loops on the Inflatable
Cover (4). Attach the latch on the strap to the buckle
on the other end of the strap. Make sure that the
cutout in the Inflatable Cover is lined up with the
warning label on the Spa Cover. Attach the other
three straps on the inside of the Spa Cover through
the loops on the Inflatable Cover in the same way.
Place the Spa Cover over the spa and line up the
cutout in the Inflatable Cover with the Console (not
shown).
5. Pull down one of the straps on the Spa Cover (11)
and hold the Buckle (30) against one of the wood
panels on the spa. (Note: To position the Buckle cor-
rectly, have a second person hold the strap on the
opposite side of the Spa Cover tight.) The Spa
Cover must be tight. Do not place the Buckle
over the grooves between the wood panels. Refer
to the inset drawing. Remove the latch from the
Buckle (30). Attach the Buckle to the wood panel with
two #4 x 3/4Ó Screws (31). Note: It may be helpful
to use a drill with a 1/16Ó bit to make starter holes
in the wood panel. It may also be helpful to apply
a little soap or wax to the screw threads.
Attach the other five Buckles (30) to the wood panels
in the same way.
Remove the Spa Cover (11) and the Inflatable Cover
(not shown) from the spa.
3
4
Fill to Here
29
Loop
Buckle
Strap
Warning
Label
Cutout
Latch
4
11
5
11
30
Strap
Strap
Latch
30
31
19
8
33
16