Filter
Top Products
English-21
DELIVERY SERVICING
7. In the space to the left of the hydraulic
tank, cut the cable tie holding the rod to
the top of the seat. Remove the split
cotter, swing the seat backwards and
connect the rod to the seat. Replace the
split cotter.
Check that the contactor on the cable to
the bottom of the seat is connected.
Swing the seat down and check that it is
held by the catch on the left.
8. Fit the armrests. Position the armrests
with the greatest possible distance
between them. The bolt heads should be
on the inside (i.e. towards the seat back)
and washers and nuts on the outside.
Armrests, bolts, washers and anti-slip
nuts are packed in a plastic bag
accompanying the mower.
9. Check the engine oil level.
With the mower standing on a flat
surface, check the engine oil level.
Unscrew the dipstick and pull it out. Wipe
the dipstick dry and push it back.
Do not screw the dispstick down.
Pull the dipstick up again and read the oil
level.
8011-504
Connnecting the rod to the seat
IMPORTANT INFORMATION
Risk of incorrect assembly/fitting
8011-505
Fitting the armrests
8011-501
Checking the engine oil level