Filter
Top Products
English-52
ELECTRICAL SYSTEM
Welding
The following applies to arc, MIG, TIG and all other electrical welding methods.
The engine’s ignition system has sensitive electrical components. Electrical welding must not, therefore, be
carried out on the engine. Remove the component to be welded (e.g. the muffler) or the ignition system.
Before carrying out welding on any other part of the mower:
1. Remove the battery cables.
2. Disconnect the connector between the engine pigtail and the frame harness.
3. Connect the welding earth lead as near as possible to the point of welding.
IMPORTANT INFORMATION
When performing electric welding on the
mower, take all necessary precautions to
prevent damage to the electrical system.