Filter
Top Products
English-31
REPAIRS
inlet.
14. Connect and adjust the gas and choke
wires (see below).
15. Check that the oil drain valve is closed
and fill the engine with oil (see Delivery
Servicing\Delivery Service).
16. Connect the positive cable (red) to the
battery’s positive terminal.
17. Open the fuel valve.
Dismantling and Assembling
Adjustments and Specific Repairs
See the Kawasaki Service Manual for the engine and auxiliary systems.
Troubleshooting
See section 8 of the Kawasaki Service
Manual.
The above section contains a troubleshooting guide for the engine and auxiliary systems. It also has
separate troubleshooting instructions for the starter motor.
Adjusting the Throttle Wire
Adjusting Throttle Lever Tension
If there is insufficient throttle lever friction,
throttle settings can alter while the mower is
being operated. This can be corrected via the
lever’s pivot bolt.
1. Free the control console and pull
forwards.
2. Tighten the throttle lever’s pivot bolt.
Checking and Adjusting the Throttle Wire
Check that the engine responds to the throttle
control and that the correct engine speed is
achieved at full throttle.
If adjustment is necessary, adjust the lower
wire as follows:
1. Loosen the clamping screw holding the
wire’s outer casing and set the lever to
the full throttle position.
2. Check that the throttle wire is attached to
the correct hole in the lower lever, see
8011-599
Freeing the controle console
8011-554
Checking and adjusting the throttle wire