Filter
Top Products
English-50
ELECTRICAL SYSTEM
Fitting
The fitting procerdure is the reverse of the removal procedure.
Pay particular attention to the following:
• The tightening torque for the bolt (9) is 67 Nm (50 ft/lb).
• With the bolt (9) tightened, there should be perceptible play between the clutch and the clutch tie down
(10) when the clutch flange is turned by hand. If necessary, adjust/twist the tie down.
• Ensure that the cable cannot be damaged and secure it with a cable tie.
Motion Control Switches
These micro switches are difficult to access. By pulling the control console forwards, it is possible to change
the right switch without any other major dismantling. However, this does require two people. When
changing the left switch, the tubular shafts (31, 33) of the motion control levers must be lowered or
removed. The procedure for doing this is detailed below and may also be used for the right switch.
8011-589
Hydraulic pump linkages