Filter
Top Products
English-49
MAINTENANCE
To level deck
Adjust the deck while the mower is on a level
surface. Make sure the tires are inflated to
the correct pressure. See “Technical Data” on
page 64. If tires are under or over inflated,
you can not properly adjust your deck.
NOTE: It may be easier to adjust the front lift
linkages by removing the floor pan before any
adjustments are made.
Side-to-side adjustment
1. Raise the deck into the highest cutting
position 4 1/2" (114 mm)
2. Measure height from the bottom edge of
the deck to the ground at both front
corners. Distance “A” at both corners
should be the same.
3. If adjustment is necessary, make
adjustment to one side of the deck only.
4. To raise one side of the deck, using a
9/16" wrench, tighten the hex nuts on
both the front and rear lift linkages (be
sure to tighten equal amounts).
5. To lower one side of the deck, reverse
previous step.
6. Recheck measurements after
adjustment.
CZ-16
Distances A
1
2
CZ-17
1. Hex nut
2. Front lift linkage
Front adjustment
CZ-18
1. Hex nut
2. Front lift linkage
Rear adjustment