Filter
Top Products
English-43
MAINTENANCE
Checking the Parking Brake
Visually check that no damage is found on
the lever, links, or switch belonging to the
parking brake. Perform a stand-still test and
check that there is sufficent braking action.
To adjust the parking brake, contact the
Husqvarna service workshop.
Checking the V-belts
Check every 100 hours of operation. Check
for severe cracking and large nicks.
NOTE: The belt will show some small cracks
in normal operation.
The belts are not adjusable. Replace belts if
they begin to slip from wear.
Deck belt
To replace deck belt
Deck belt removal.
• Park on a level surface. Apply park
brake.
• Lower the deck into the lowest cutting
position.
• Disengage the tension relief lever from
the lock bracket.
• Remove screws from both the left and
right belt shields, and remove shields.
• Remove any dirt or grass that may have
accumulated around the cutter housings
and entire deck surface.
8011-711
The parking brake in the disengaged position
IMPORTANT INFORMATION
The maschine must be absolutely stand
still when applying the parking brake.
WARNING!
Faulty adjustment can cause
an accident.
8011-764
1. Clutch pulley
2. Deck belt
Belt routing, deck belt
1
2
WARNING!
Lever is spring loaded. Have a
tight grip on the lever and
release slowly.