Filter
Top Products
10 – English
ASSEMBLY
Fitting the handlebar
Take care not to damage the cables and wires when you fold
up the handlebar.
The upper part of the handlebar is attached with a sturdy
handle nut on the baffle plate. Don't forget the washer
between the plate and the handle nut.
If necessary, the handle can be turned slightly sideways with
the handle joint. The handle can be set to different positions
to achieve the best driving position, e.g. when mowing next to
hedges or house walls.
The handle can also be adjusted vertically by turning the
wheels by the attachment fitting on the chassis
Dismantling and assembling the
cutter
The ignition lead should always be removed from the spark
plug before repair, cleaning or maintenance work.
Position the cutter with the spark plug upwards when
servicing the machine.
Always empty the fuel tank before you place the lawn mower
on its side.
Dismantling
• Unscrew the bolt holding the cutter.
• Remove the bolt, spring washer and cutter.
Assembly
• Place the cutter with the friction washer against the cutter
bracket.
• Make sure the cutter centres correctly on the shaft.
• To avoid vibrations, place the mower cutter so that the
cutter bracket marking can be seen on the sides of the
cutter.
• Fit the washer and tighten the bolt correctly. The bolt
should be tightened with a torque of 45-60 Nm.
Assembling the mulching plugs
• Disconnect the HT lead from the spark plug.
• Position the cutter with the spark plug upwards when
servicing the machine.
• Fit the leader pins into the holes on the cutting cover.
• Fasten the mulching plugs from the top of the cutting
cover.
!
WARNING! Always wear heavy-duty gloves
when servicing and maintaining the cutting
equipment. The cutters are very sharp and
cuts can occur very easily.