Filter
Top Products
22
SERVICE
RECORDS
SCHEDULE SERVICE
DATES
Fill in dates as
you complete
regular service
MAINTENANCE
LUBRICATION - EVERY TEN HOURS
● Auger Shaft - Using a hand grease gun, lubricate the
auger shaft zerk fittings (See III.17) every ten (10) ●
See Lubrication Chart diagram for lubrication points
and type of lubricant.
LUBRICATION - EVERY 25 HOURS
● Position speed selector lever in first gear.
● Place a coin or (a shim of equal thickness) be-
tween the rubber friction wheel and disc drive plate
to prevent friction wheel contacting the friction disc.
● Disc Drive Plate - Using a hand grease gun, lubri-
cate with a Hi Temp EP Moly grease, zerk located
beneath the disc drive plate (See III.19, inset) every
25 hours and at the end of the season and/or before
storage. To grease zerk, turn disc drive plate clock-
wise by hand until zerk is clearly visible at front
center. DO NOT overfill or allow grease to come in
contact with the disc drive plate or friction wheel or
damage will result. Fill zerk only until grease be-
comes visible below bearing assembly located un-
der grease zerk. See Lubrication Chart.
GENERAL RECOMMENDATIONS
The warranty on this snow thrower does not cover items
that have been subjected to operator abuse or negli-
gence. To receive full value from the warranty, operator
must maintain snow thrower as instructed in this manual.
Some adjustments will need to be made periodically to
properly maintain your snow thrower .
All adjustments in the Service and Adjustments section
of this manual should be checked at least once each
season.
AFTER EACH USE
● Check for any loose or damaged parts.
● Tighten any loose fasteners.
● Check and maintain the auger.
● After each use, remove all snow and slush off the
snow thrower to prevent freezing of auger or con-
trols.
● Check controls to make sure they are functioning
properly.
● If any parts are worn or damaged, replace immedi-
ately.
● Change the oil after first two (2) hours of use.
SNOW THROWER
LUBRICATION - EVERY FIVE HOURS
● Lubricate the flange on the discharge chute every
five (5) hours during use and before storage.
● See Lubrication Chart (Page 11, III 16) diagram for
lubrication points and type of lubricant.
After
First 2
hours
Before
Each
Use
Check Engine Oil Level
Change Engine Oil
Tighten All Screws and Nuts
Check Traction and Auger Clutch
Cable Adjustment (See Cable
Adjustment)
Replace Spark Plug
Adjust Drive Belts
Lubricate All Pivot Points
Lubricate Auger Shaft (See Shear
Bolt Replacement)
Lubricate Drive Chains
Check Fuel
Drain Fuel
Often
Every
5
Hours
Every
10
Hours
Every
25
Hours
Each
Season
Before
Storage