Filter
Top Products
27
OPERATION
Before Starting
1. Read the sections on Safety and Controls before
starting the machine.
2. Perform the daily maintenance before starting
(see Maintenance Schedule in the Maintenance
section).
3. Check that there is sufficient fuel in the fuel tank.
4. Adjust the seat to the desired position.
8058-255
Secure selected cutting height
5. Set the deck cutting height by inserting the lift pin
into the desired cut height.
8058-252
Lengthways adjustment
The following conditions must be fulfilled before the
engine can be started:
• The blade switch must be pressed downward into
the disengaged position.
• The park brake must be up into the activated
position.
• Both steering controls must be in the locked
(outer) neutral position.