Filter
Top Products
26
OPERATION
1
2
SmartSwitch Ignition
NOTES: The default passcode [321] is preset at the
factory. For safety and security, the passcode should
be changed prior to use.
Resetting ignition system passcode
1. To initialize the ignition system, press the START/
STOP (S/S) button on the ignition switch or sit on
the seat. The blue indicator will blink, showing the
system is operational.
2. Using the lower buttons, press and hold the
(1) and (3) buttons at the same time for three
seconds. The blue indicator will then be lit
continuously, signalling the system is ready to
accept a new code.
3. Using the lower buttons, enter a desired code of
numbers from one to five digits and then press the
S/S button. The indicator will blink green to signal
the passcode has been accepted.
4. If the S/S button blinks red, the passcode reset
has not been accepted. Wait for the S/S button to
return to blinking blue and retry the programming,
starting at Step 1.
8058-235
1. Start/Stop Button
2. Numbered buttons
Press buttons to enter new passcode
8058-236
Enter passcode and then press the S/S button