Filter
Top Products
English
–
3
Ser
vice journal
Pre-deliver
y service
1
Charge the battery for at least 4 hours at max. 3
amp.
2 Check coolant level and antifreeze.
3 Check and adjust tyre pressure (150 kPa, 1,5 bar,
21,8 PSI).
4 Make sure the correct amount of oil is in the
cutting unit's bevel gear.
5 Check that the right amount of oil is in the engine.
6 Check that there is oil in the transmission’s oil
tank.
7 Fit cutting unit.
8 Adjust cutting unit:
Adjust cutting unit so that rear edge is about 6-9
mm higher than front edge.
9 Lubricate the universal drive shaft with grease.
10 Connect battery.
11 Fill with fuel and start engine.
12 Check that machine does not move in neutral.
13 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Safety switch for parking brake.
14 Tell customer about:
The requirement and advantages of servicing the
machine according to the service plan
Servicing and the influence of this journal on the
second-hand value of the machine.
The transmission guarantee is only valid if the
synchronisation of the front and rear wheels has
been checked and adjusted in compliance with
the service schedule. The system will be damaged if
synchronisation is not carried out.
At temperatures below 0
°
C, the machine must
be warmed up for at least 10 minutes for the
hydraulic oil and transmission to get hot.
Otherwise there is a risk of the transmission breaking
down thereby reducing the service life of the transmission.
Range of applications for BioClip.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems.
Certified:
______________________________________________
Date, mileage, stamp, signature
After the fi
rst 25 hours
1
Change the engine oil and oil filter
2 Change the transmission oil and oil filter
3 Check the synchronisation between the front and
rear wheels.