Filter
Top Products
English – 15
PRESENTATION
The power outlet is switched on and off using power switch on
the control panel.
The power outlet works even if the ignition is turned off. Do
not forget to disconnect the power outlet or remove the power
consumer when the machine is not in use.
The voltage is 12 V.
The power outlet is fuse protected by its own fuse. The fuse
for the power outlet is placed in the electrical connection box,
behind the side plate on the control panel.
Instrument panel
The indicator lights are on the steering console under the
steering wheel.
1 Temperature gauge for coolant. The engine is liquid
cooled. If overheating of the engine is indicated the first
action to take is to reduce the engine temperature by
running the engine at idle with no load. Turn off the power
transmission
Check coolant level and top up if necessary. Also check
that the radiator grill and radiator are clean and not
clogged. The grill is at the rear of the machine and on top
of the bonnet.
2 Oil pressure, check oil level and top up if necessary.
3 Ignition
4 Battery charging
5 Power transmission connected
6 Parking brake
7 Spotlight
8 Switch for the lights
Bypass valves
Hydraulic pressure must be released in order for the ride-on
mower to be moved when the engine is shutoff.
The hydraulic pressure is opened and closed with a bypass
valve.
If you try to drive the machine without hydraulic pressure, it
will not move. The drive on the axle is disengaged if one valve
is open.
The P 520D and theP 525D has two valves, one valve for the
front axle and one for the rear axle.
• Bypass valve rear axle
- The hydraulic pressure is released by opening the locking
nut (1) 1/4-1/2 turn anti-clockwise, then the bypass valve (2)
2 turns.
- The hydraulic pressure is switched on by closing the valve.
Close the valve nut (2) fully before tightening the locking nut
(1).
• Bypass valve front axle
- The hydraulic pressure is released by opening the locking
nut (1) 1/4-1/2 turn anti-clockwise, then the bypass valve (2)
2 turns.
- The hydraulic pressure is switched on by closing the valve.
Close the valve nut (2) fully before tightening the locking nut
(1).
123456
7
8
IMPORTANT! Always drive the machine with both valves
closed.