Filter
Top Products
26 – English
Maintenance
Check the battery
The machine is equipped with a maintenance-free battery.
The battery has a service window showing different colours.
• White = Charge battery
• Green = OK.
• Red = Change battery.
Clean the battery and holder with soap/water solution.
A discarded or replacement battery should be handled as
hazardous waste.
The Cutting Unit Components
The components mentioned are:
1 Cotter pin
2 Link joint
3 Cutting unit bracket
4 Clipping height adjusters
5 Universal drive shaft with quick connectors
6 Attachment point for service position
7 Service strut
8 Belt cover
9 Gear
Fitting the cutting head
1 Place the machine on a flat surface and apply the parking
brake.
2 Start the engine and lower the lift arms to floating mode.
3 Turn off the motor.
4 Fit the universal drive shaft to the cutting unit. Slide the
ring sideways to release the quick coupling and the
universal drive shaft can be pushed onto the shaft pin.
5 Make sure the rubber casing is folded over the front
universal joint.
6 Remove the bolts and pins from the link joint on the lift
arms.
7 Slide in the cutting unit so that the link joint aligns with the
opening in the unit.
8 Insert the bolts for the link joints and the pins on both
sides.
!
WARNING! Lead-acid batteries produce
explosive gases. Avoid sparks, open flames
and smoking close to batteries. Always wear
protective glasses in the vicinity of batteries.
4
1
5
3
2
6
7
4
8
9
!
WARNING! If the help function is engaged,
the lift arms will move with great force if
someone releases the lifting lever. Observe
caution to avoid trapping your hand.
Risk of crush injuries.