Filter
Top Products
8
1. Remove the discharge chute from the deck.
(Deck confi guration will vary by size and model)
2. Lower deck to the lowest cutting position.
3. Remove the right hand (discharge side) belt
cover from the deck.
4. Relieve the tension from the deck belt and re-
move from the center deck pulley.
(See Operator’s Manual if necessary)
5. Remove the nut that secures the right hand
deck pulley to the spindle.
6. Install drive pulley included
in collection system kit on
top of the current deck
pulley.
7. Reinstall the nut on the
spindle and torque to 55-75
ft/lbs.
8. Reinstall the deck belt.
ASSEMBLY
1
INSTALLING DRIVE PULLEY
Discharge Chute
Belt Cover
1. Place blower assembly on secure table or stable
surface.
2. Remove the bolts securing the rear mount
bracket.
3. Using the hacksaw, trim the blower housing
along the recessed grooves.
4. Reinstall the rear mount bracket with previously
removed bolts.
2
TRIMMING BLOWER
(52" and 61" decks only)
Mount Bracket Rear
Tension Release Lever
Deck Height Adjustment
Drive Pulley
52/61 Trim Line