Filter
Top Products
11
1. Remove the top right mount strap from the rear
of the mower and save hardware.
2. Remove the right rear skid plate bolt and the
lower right mount strap bolt from the mower and
save hardware.
3. Place the bagger mount bracket against the rear
of the engine guard, reinstall the upper right
mount strap and secure with 1" carriage bolts
and previously removed nuts.
4. Tighten all hardware.
7
TRIMMING MIDDLE CHUTE
(42" and 48" decks only)
8
INSTALLING MIDDLE CHUTE
1. Using the hacksaw, trim along the dashed line.
2. Locate the middle chute, fl at washer, hood latch,
weld nut, lock washer and machine screw from
kit.
3. Install in the appropriate hole at the upper end of
the middle chute, according to deck size.
1. Place middle chute over the top end of the
blower assembly.
2. Latch middle chute to blower assembly.
42/48 Trim Line
Middle Chute
Hood Latch
Weld Nut
Machine Screw
Lock washer
52/61 Hole
42/48 Hole
Flat Washer
9
INSTALLING BAGGER MOUNT
2 Bin Collector
Remove
Mount Strap
Mount Strap
Middle Chute
Blower Assembly
Skid Plate
Bagger Mount Bracket
Carriage Bolts
ASSEMBLY