Filter
Top Products
7
ASSEMBLY
6
BAGGER MOUNT
1. Using 1¾" round head shoulder bolts and nuts,
attach the mount hitch to the mount tube as
illustrated. Make sure the elbowed arm of the tube
is on the right side, with the mount hitch installed
to the front.
2. Attach the support bracket to the tube assembly
with two 1¾" round head shoulder bolts and nuts.
3. With a 1" hex bolt and nut, secure the lower mount
hitch to the frame.
4. Install the mount straps (bends are to the inside)
on the outside of the mount tube using 2" hex
bolts and nuts. The front side of the mount straps
are secured to the fuel tank brackets with 1" round
head shoulder bolts and nuts.
5. To prevent contact of the left hand strap with
the EFM (Electronic Fuel Management) box on
the engine, place the foam strip on the inside of
the strap, next to the box. (Illustration location is
approximate.)
6. It may necessary to drill holes into the rear
guard to accept the hardware for the support
bracket and spacer plate. Using the bracket as a
template, drill
5
/16" holes.
7. Slip the spacer plate between the support bracket
and the rear guard and attach both to the rear
guard with ¾" hex bolts and nuts as illustrated.
8. Tighten all hardware.
Support Bracket
Lower Mount Hitch
FRONT
Mount Straps
Spacer Plate
Mount Tube
Support Bracket and
Spacer Plate
Foam Strip