Filter
Top Products
5
ASSEMBLY
1. Remove the discharge chute from the deck
by removing the side hardware from the chute
bracket. Retain the hardware for reuse if the
collection system is removed.
2. Lower deck to the lowest cutting position.
3. Remove the right hand (discharge side) belt cover
from the deck.
4. Relieve the tension from the deck belt and remove
the belt from the center deck pulley.
(See Operator Manual if necessary)
5. Remove the nut securing the right hand deck
pulley to the spindle.
6. Install drive pulley included in collection system
kit on top of the current deck pulley.
7. Reinstall the nut on the spindle and torque to 55-
75 ft/lbs.
8. Reinstall the deck belt.
1. Place blower assembly on secure table or stable
surface.
2. Remove the bolts securing the rear mount
bracket.
3. Using the hacksaw, trim the blower housing along
the recessed grooves.
4. Reinstall the rear mount bracket with previously
removed bolts.
Mount Bracket
Rear
Trim Line
1
DRIVE PULLEY
2
TRIMMING BLOWER
Belt Cover
Discharge
Chute
Hardware
Drive Pulley
3
MOUNTING BLOWER ASSEMBLY
Outer Pulley Cover
Pin
1. Position blower over the discharge tabs on the
deck and set blower onto the deck.
2. Install the front mount bracket to the deck with the
pin and hairpin cotter supplied with the kit.