Filter
Top Products
ASSEMBLING AND ADJUSTMENTS
12 – English
General
Husqvarna’s blades are high speed blades approved for
hand held power cutters.
Checking the drive shaft and
flange washers
When the blade is replaced with a new one, check the
flange washers and the drive shaft.
• Check that the threads on the drive shaft are
undamaged.
• Check that the contact surfaces on the blade and the
flange washers are undamaged, of the correct
dimension, clean, and that they run properly on the
drive axle.
Do not use warped, notched, indented or dirty flange
washers. Do not use different dimensions of flange
washers.
Checking the bushing
Bushings are used to fit the machine to the centre hole in
the cutting blade. The machine is supplied with a bushing
that can be flipped over to fit either 20 mm or 1” (25.4
mm). A decal on the blade guard indicates appropriate
blade specification.
• Check that the bushing on the machine's spindle shaft
corresponds with the centre hole of the cutting blade.
The blades are marked with the diameter of the centre
hole.
Use only bushings supplied by Husqvarna. Those
bushings have been designed for your power cutter.
Checking the direction of the
blade rotation
• When using diamond blades make sure that it rotates
in the direction indicated by the arrow on the blade.
The direction of rotation for the machine is shown by
arrows on the cutting arm.
Fitting the cutting blade
• The blade is placed on the bushing (A) between the
inner flange washer (B) and the flange washer (C).
The flange washer is turned so that it fits on the axle.
• Lock the shaft. Insert a tool in the hole in the cutting
head and rotate the blade until it is locked.
• Tightening torque for the bolt holding the blade is: 25
Nm (215 in.lb).
Blade guard
The guard for the cutting equipment should be adjusted
so that the rear section is flush with the work piece.
Spatter and sparks from the material being cut are then
collected up by the guard and led away from the user.
The blade guard is friction locked.
• Press the ends of the guard against the work piece or
adjust the guard with the adjustment handle. The
guard must always be fitted on the machine.
!
WARNING! The engine should be
switched off, and the stop switch in
STOP position.