Husqvarna HUV 4421-G / GXP Utility Vehicle User Manual


 
Engine Oil
2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual Page 35
NOTE: The normal oil pressure value stated in the Honda engine manual is 28 psi at idle; however, the
remote filter design causes oil pressure to be 18 psi, which is normal for this type of oil circulation
design.
Kawasaki engine: The Kawasaki gasoline engine has an oil filter that is mounted on a bracket between and
in front of the engine and transmission. Inlet and outlet oil-carrying hoses enable oil circulation to and from the
engine. See following NOTE.
NOTE: The normal oil pressure value stated in the Kawasaki engine manual is 35-45 psi at idle; however,
the remote filter design causes oil pressure to be 18 psi, which is normal for this type of oil circula-
tion design.
ENGINE OIL LEVEL CHECK
1. Remove the oil level dipstick from the oil filler tube and wipe oil from the dipstick. See Figure 18,
Figure 19, Figure 20, and Figure 21, on page 36. See following CAUTION.
ý CAUTION
Do not remove dipstick while engine is running.
2. Check oil level by fully inserting the dipstick into the tube and immediately removing it.
3. If the oil level is at or below the low level mark on the dipstick gauge, add oil to the engine until the level
is between low and full levels (safe level). See following CAUTION.
CAUTION
Do not fill oil above the full level mark. Doing so will result in decreased engine performance
or damage to the engine.
Figure 18 Engine Oil Level Check –
Honda Gasoline Vehicles
Figure 19 Engine Oil Level Check –
Kawasaki Gasoline Vehicles
Full
Low
Level
Safe
Level
Level
1
2
3
Full
Low
Level
Safe
Level
Level
1
2
3