Filter
Top Products
Pre-Operation and Daily Safety Checklist
Page 20 2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual
CAUTION
• Failure to add oil immediately when the low oil warning light stays on may result in permanent
engine damage.
HEADLIGHT CONTROL
The headlight control (2) is located on the dash to the left of the key switch (Figure 14). Pull out to turn the
lights on, push in to turn the lights off. The headlights operate on 12 volts DC from the battery. See following
NOTE.
NOTE: Using the headlights for extended periods of time without the engine running, or with the engine
idling, will discharge the battery.
12-VOLT OUTLET ACCESSORY
Some vehicles are provided with a 12-volt outlet, protected with a 10 amp fuse, located in the fuse box under
the seat. To use, push in a cord designed for this type of outlet.
Be sure to disconnect electronic devices from the accessory outlet before the vehicle batteries are charged.
See following CAUTION.
ý CAUTION
• Do not leave electronic devices connected to the accessory outlet while the vehicle batteries
are being charged. The voltage output can fluctuate from 12 volts to 19 volts while the vehicle
batteries are charging, and this voltage fluctuation can damage some electronic devices.
To remove a power cord from the accessory outlet, rotate it counterclockwise, align the arrows and pull the
cord out of the outlet.
Extended use of this accessory can cause the batteries to become heavily discharged. If the vehicle batteries
become deeply discharged, charge the batteries as instructed in the owner’s manual appropriate to the vehi-
cle, or contact your local Husqvarna dealer for instructions.
Inspect the accessory outlet periodically to ensure the electrical connection is clean and free of corrosion.
PRE-OPERATION AND DAILY SAFETY CHECKLIST
Each Husqvarna vehicle has been thoroughly inspected and adjusted at the factory; however, upon receiving
your new vehicle(s), you should become familiar with its controls, indicators, and operation. Carefully inspect
each vehicle to ensure that it is in proper working condition before accepting delivery.
Use the following checklist as a guide to inspect the vehicle. This checklist should be used daily to ensure that
the vehicle is in proper working condition and in conjunction with the Periodic Service Schedules on page 32.
Any problems should be corrected by a Husqvarna distributor/dealer or a trained technician.
• General: All the parts should be in place and properly installed. Be sure that all nuts, bolts, and screws
are tight. On gasoline vehicles check all hose clamps for tight fit as well as the starter belt for tightness.
• Safety and information decals: Check to ensure that all safety and information decals are in place.
See Safety Decal and Feature Identification on page 4.
• Tires: Check for proper tire pressure. Visually inspect tires for wear, damage, and proper inflation on a
daily basis. See Vehicle Specifications on page 50.