Filter
Top Products
18
MAINTENANCE
TRACTOR
Always observe safety rules when per form ing any
main te nance.
BRAKE OPERATION
If tractor requires more than five (5) feet to stop at highest
speed in high est gear on a level, dry concrete or paved
surface, then brake must be checked and ad just ed. (See
“TO CHECK BRAKE” in the Ser vice and Ad just ments
section of this manual).
TIRES
• Maintain proper air pressure in all tires (See the sides
of tires for proper PSI).
• Keep tires free of gasoline, oil, or insect control
chemi cals which can harm rubber.
• Avoid stumps, stones, deep ruts, sharp objects and
other hazards that may cause tire damage.
NOTE: To seal tire punctures and pre vent flat tires due
to slow leaks, tire sealant may be purchased from your
local parts dealer. Tire sealant also pre vents tire dry rot
and corrosion.
OPERATOR PRESENCE SYS TEM AND REVERSE
OPERATION SYSTEM (ROS) (See Fig. 23)
Be sure operator presence and reverse operation sys tems
are work ing properly. If your tractor does not function as
described, repair the problem immediately.
• The engine should not start unless the brake pedal is
fully de pressed, and the attachment clutch con trol is
in the dis en gaged position.
CHECK OPERATOR PRESENCE SYSTEM
• When the engine is running, any attempt by the op er a tor
to leave the seat without first setting the parking brake
should shut off the engine.
• When the engine is running and the at tach ment clutch
is engaged, any attempt by the operator to leave the
seat should shut off the engine.
• The attachment clutch should never operate unless
the operator is in the seat.
CHECK REVERSE OPERATION (ROS) SYSTEM
• When the engine is running with the ignition switch in
the engine "ON" position and the at tach ment clutch
engaged, any attempt by the operator to shift into
reverse should shut off the engine.
• When the engine is running with the ignition switch
in the ROS "ON" position and the at tach ment clutch
engaged, any attempt by the operator to shift into
reverse should NOT shut off the engine.
Fig. 23
Fig. 24
RH
BLADE BOLT
RIGHT HAND
THREADED
LOCK
WASHER
FLAT
WASHER
BLADE
MANDREL
ASSEMBLY
5 STAR
PATTERN
5 STAR CENTER HOLE
TRAILING
EDGE
Fig. 25
02
223
6 STAR PATTERN
BLADE WITH
LEFT HAND
THREAD ED BOLT
5 STAR PATTERN
BLADE WITH
RIGHT HAND
THREAD ED BOLT
5 STAR PATTERN BLADE (See Fig. 25)
The center of this blade has a five (5) star pattern. The bolt
that attaches this blade has nor mal Right Hand threads
that loosens by turn ing ( ) counterclockwise and tight ens
by turning ( ) clockwise.
BLADE CARE (See Fig. 24)
For best results mower blades must be kept sharp. Replace
bent or damaged blades.
IMPORTANT: THE BLADES ON YOUR MOW ER ARE NOT THE
SAME AND MUST BE INSTALLED ON THE CORRECT SIDE. IT
IS SUG GEST ED THAT YOU WORK ON ONE BLADE AT A TIME
TO ENSURE PROP ER ASSEMBLY OF COMPONENTS.
CAUTION: Use only a replacement blade ap-
proved by the manufacturer of your tractor.
Using a blade not approved by the manu-
facturer of your tractor is hazardous, could
damage your tractor and void your warranty.
ROS "ON"
POSITION
ENGINE "ON" POSITION
(NORMAL OPERATING)
0
2
8
2
8