Filter
Top Products
English - 15
OperationOperator's Manual CS 2512
Cleaning
The saw should be cleaned once cutting is finished. It is
important to clean all the saw equipment. It is a good idea
to disconnect the water hose from the pivot arm and use
this to wash down the saw unit. If necessary, you can also
use the supplied cleaning brush or the like to clean the
equipment. Do not use a high pressure washer to clean
the saw.
Maintenance
In addition to the daily maintenance such as cleaning and
lubrication, the machine must be serviced. After 50 hours
of cutting, the machine should be serviced at an
accredited Husqvarna workshop. The saw should then be
serviced after every 100 hours of operation. The service is
important so that as the user you have a machine that
works as effectively as possible for a long time.
Lubrication
In order for the wire to run as friction free as possible, the
magazine axles must be filled with grease. Fill with grease
after every 5 -10 hours of operation. Use Canadian
Petroleum OG2 or similar grease.
The bearings on the magazine axles also need to be
lubricated regularly, but not as often as the magazine
axles.