7
ASSEMBLY
1
HEX BOLT
LOCKNUT
ACORN NUT
DISCHARGE
GUARD
LOCKNUT
MOWER DECK BAFFLE (See Fig. 1)
Use Hardware - - GROUP "A"
• Raise your tractor mower deck to its highest position.
• Install the hex bolts, locknuts and acorn nuts through
mower deck housing as shown.
• Tighten all hardware securely.
ACORN NUT
FIG. 1
2
REAR MOUNTING BRACKET
(See Figs. 2A & 2B)
NOTE: If your tractor already has four (4) shoulder bolts
installed on the rear drawbar, simply hang the mounting
bracket, lanced tabs towards bottom, on the bolts. Discard
hardware group "B" and disregard the remaining Step 2
instructions.
LANCED TABS
TOWARD BOTTOM
SHOULDER
BOLTS
FIG. 2A
If your tractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructions below.
Use Hardware - - GROUP "B"
• Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
• Hang the mounting bracket, lanced tabs towards bottom,
on the bolts.
SELF
TAPPING
SHOULDER
BOLTS
FIG. 2B
LANCED TABS
TOWARD BOTTOM
HEX BOLT
ALIGNMENT
MARKS
COVER SEAL
FIG. 3
COVER SEAL (See Fig. 3)
No hardware required
• Align mark on seal with mark at cover opening.
• Work seal into opening so cover sits between flanges of
seal.
3
SUPPORT POST (See Fig. 4)
Use Hardware - - GROUP "C"
CAUTION: Container support is spring
loaded and locked to the cover. Handle
cover assembly carefully so as not to
unlatch the cover from the container
support.
• Rotate cover assembly onto its side as shown.
• Assemble support post to container support with the
three (3) carriage bolts and locknuts. Tighten securely.
4
FIG. 4
LOCKNUTS
CARRIAGE
BOLTS
SUPPORT
POST