Filter
Top Products
46
Lubricating the Cables
If possible, grease both ends of the cable and move the controls to end stop positions when lubricating.
Refit the rubber covers on the cable after lubrication. Cables with sheaths will bind if they are not lubricated
regularly. If a cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it vertically. Lubricate it with thin engine oil until the oil begins
to escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that it seals against the sheath and allow the cable to hang
vertically from the bag overnight. If you do not succeed in lubricating the cable, it must be replaced.
Lubricating in Accordance with the
Lubrication Schedule
1. Hydraulic System, Oil Level
The hydraulic oil and filter shall be replaced every
300 hours, and at least once a year. Contact an
authorized service workshop.
Check the oil level in the hydraulic tank daily. The
level should be about 3/4"-1" below the top of the
tank.
Check connections, hoses, and tubes for damage
or leaks. Replace or repair if doubtful.
LUBRICATION
Checking the hydraulic oil
8011-565
Lubricating the lengthways adjuster under the
seat
Changing Oil and Filters
Oil and filter changes should be carried out by an
authorized service center.
WARNING!
If a leak is suspected, use a piece of card-
board or wood, NOT your hands. to check
for leaks.
Escaping hydraulic oil under pressure can
have sufficient force to penetrate the
skin, causing serious injury.
If injured by escaping fluid, see a doctor
at once. Serious infection or reaction can
develop if proper medical treatment is not
administered immdediately.
2. Driver’s Seat
Tip the seat.
Lubricate the linked mount at the front using an oil
can.
Lubricate the lengthways adjustment mechanism
with the oil can.
Lubricate the lengthways adjustment runners with
the oil can.