19
Throttle Control
The throttle control regulates the engine speed.
In order to increase or decrease the engine speed,
the control is moved forward or backward
respectively.
Avoid idling the engine for long periods.
Use full throttle when mowing.
Ignition
The ignition key is placed in the front console and
is used to start the machine.
Hour Meter
The hour meter displays the total operating time
and reminds of service intervals.
It will flash CHG OIL (Change Oil) at 50 hour
intervals. The flash duration is one hour before
and one hour after the interval. The CHG OIL icon
will come on and shut off automatically. The hour
meter can not be manually reset.
CONTROLS
Gauges
Water temperature gauge- indicates coolant
temperature and warns of overheat situation.
Ammeter - indicates amount of electrical flow at
the battery. Under normal operating conditions the
needle will be slightly on the plus (+) side of the
gauge, showing that current is being supplied to
the battery. At idle speed, the indicator may be at
zero or on the negative (-) side. A continuous
negative reading at normal operating speed
indicates a malfunction in the charging system that
should be checked immediately.
Oil pressure meter - tells what the pressure is in
the oil system and warns if pressure is too low for
operation.
IMPORTANT INFORMATION
Wait till the glow plug light goes out before
turning the engine over. To prolong starter
life use short starting cycles, DO NOT
exceed 30 secs./min.
WATER TEMPERATURE
AMMETER
OIL PRESSURE
Gauges
THROTTLE CONTROL
Throttle control
Console
GLOW PLUG LIGHT
IGNITION
HOUR METER
BAM-2
BAM-2
CONSOLE