Filter
Top Products
54 Automower from
6. Menu functions
™
Up to three remote areas can be activated:
Area 1, Area 2 and Area 3. Three values need to
be stated to activate an area:
•Direction
Specify to the right or left, depending on which
direction the area lies from the charging
station. The direction is set looking from the
charging station in the approach direction of
the mower. In the above example the direction
is to the Left.
When a guide wire is installed the direction can
be specified as the guide wire. The mower will
then follow the guide wire instead of the
boundary wire.
• Distance
Specify the number of meters along the
boundary wire or guide wire from the charging
station to the place in the remote area where the
mower is to turn out from the boundary wire and
start mowing irregularly.
Tip! Use the Test OUT (3-2-5) function (see
page 57) to find out how far it is to the remote
area. The distance, stated in meters, will appear
on the mower display.
• Proportion
Specify a value for how often of the occasions
Automower leaves the charging station it should
follow the loop out to the remote area.
For example the value 20 % means that in 20 %
of the occasions Automower leaves the charging
station, it does it in the direction to the remote
area. In the remaining 80
% of the occasions the
mower leaves the charging station according to
the setting made for its function
Exit angles
(3-1).
If a value of 20 % is specified for Area 1 and
10
% for Area 2, the remaining 70 % is allocated
to the selection under
Exit angles (3-1).
3-2-1
Area 1
Area 2
Area 3
Follow loop out
Follow loop in
Corridor width
Test IN
Test OUT
Direction
Distance
Proportion
Area 1
Area 2
Area 3
Right
Left
Guide
Direction
Distance
Proportion