Filter
Top Products
Automower from 33
3. Installation
™
5. Cut off any surplus boundary wire. Cut 0.4" - 0.8"
above respective connectors.
6. Press the connector onto the contact pin,
marked A, on the charging station.
7. Refit the cover on the charging station. Ensure
the three guides on the charging station enter the
right holes in the cover.
3.6 Checking the installation
Check the loop signal by looking to see what
indication the green LED on the charging station is
giving.
• Steady light = the signal is okay.
• Flashing once every other second = break in the
loop and no signal found.
• Flashing twice every other second = signal
found, but the wire is probably damaged. Check
all wire connections.
IMPORTANT INFORMATION
The right hand connector should be
connected on the right hand contact pin on
the charging station and vice versa.
3012-265
3012-507
3012-270
3012-282