Filter
Top Products
36 Automower from
3. Installation
™
Placement and connection of the guide
wire
1. Check that the charging station has the best
placement.
The guide wire together with the part of the
boundary wire that makes up the return to the
charging station is known as the guide loop. The
current in the guide loop always goes to the left
in the connection between the guide wire and the
boundary wire.
The adjoining picture shows what is considered a
guide loop.
The picture is also a good example of an ideal
position for the charging station to give the
shortest possible guide loop.
The guide loop may be a maximum of 650 ft
long. When the guide loop is longer, there is a
risk Automower can not follow the guide wire.
2. Lift up the cover on the charging station.
3. Insert the end of the guide wire into the lower
right-hand hole on the charging station and catch
it in the upper hole.
4. Secure a connector on the guide wire.
5. Connect the guide wire to the contact pin on the
charging station marked G.
6. Route the cable straight under the charging
station plate.
3012-651
3012-650
3012-538