Filter
Top Products
English-46
TROUBLE SHOOTING
Trouble shooting
Fault messages
A number of fault messages are listed below that can
be shown on the display. If another message than
those listed is shown, contact your dealer.
Fault message Cause Action
Left wheel motor
blocked
Grass or other object may have
become wrapped around the drive
wheel.
Check the drive wheel and remove
the grass or other object.
Right wheel motor
blocked
Grass or other object may have
become wrapped around the drive
wheel.
Check the drive wheel and remove
the grass or other object.
Blade disc blocked Grass or another object may have
become wrapped around the blade
disc.
Check the blade disc and remove the
grass or other object.
No loop signal Wrong PIN code has been stated. State the correct PIN code.
The transformer is not connected to
the mains supply or its miniature cir-
cuit-breaker has tripped.
Check the wall socket connection and
whether the miniature circuit-breaker
has tripped.
Reset the miniature circuit-breaker by
removing the transformer’s power
cord from the wall socket, wait 10
seconds and then reconnect the
power cord in the wall socket again.
Boundary wire broken. Check the signal given by the LED on
the charging station. If it flashes the
loop is damaged. Repair the broken
cable using Husqvarna’s waterproof
connector, part number 535 13 37-01.
If this occurs in isolated areas it may
be due to interference from metallic
objects (perimeter fence, reinforce-
ment bar) or buried cables in the
vicinity.
Try to move the boundary wire.
If it occurs in the vicinity of an ”island”
it may be due to the boundary wire be
routed in the wrong direction around
”island” and thereby switching off the
signal.
Check that the boundary wire has
been routed correctly.
Trapped Auto Mower has become caught in
something.
Free the Auto Mower and rectify the
reason for it becoming trapped.