Filter
Top Products
English-
19
INSTALLATION
Remember the following with regard to the working
area boundaries:
• If a high obstacle, for example a wall or fence, bor-
ders the working area, the boundary wire should be
laid 35 cm from the obstacle. This will prevent the
Auto Mower from colliding with the obstacle and
reduce body wear.
• If the working area borders against, for example,
pools of water the boundary wire should be supple-
mented with a fence or the like. The height must
then be at least 10 cm. This will prevent the Auto
Mower, under any circumstances, coming outside
of the working area.
• If the working area borders against a small ditch, for
example, a flower bed or a small elevation, e.g. a
low verge (3-5 cm), the boundary wire should be
laid 30 cm inside the working area. This prevents
the wheels from driving into the ditch or up onto the
verge.
• If the working area borders against a flat path or the
like that lies level with the lawn, is it possible to
allow the Auto Mower to run a little over the path.
The boundary wire should then be laid 10 cm from
the edge of the path.
35 cm
3012-229
30cm
3012-228
10 cm
3012-230