Filter
Top Products
GENERAL SAFETY PRECAUTIONS
English – 11
Make sure the power trigger is locked when the power
trigger lock is in its original position.
Press the power trigger and make sure it returns to its
or
iginal position when you release it.
Check that the power trigger and the power trigger lockout
mo
ve freely and that the return spring works properly.
See instructions under the Start heading. Start the
machine and apply full po
wer. Release the power trigger
and check that the cutting attachment stops and remain at
a standstill.
Cutting attachment guard
This guard is intended to prevent loose objects from being
thrown towards the operator. The guard also protects the
operator from accidental contact with the cutting
attachment.
Check that the guard is undamaged and not cracked.
Replace the guard if it has been e
xposed to impact or is
cracked.
Always use the recommended guard for the cutting
attachment y
ou are using. See chapter on Technical data.
Cutting equipment
This section describes how to choose and maintain your
cutting equipment in order to:
• Obtain maximum cutting performance.
• Extend the life of cutting equipment.
Always remove the battery before you work on any part of
the cutting equipment.
It continues to rotate even after the
throttle control has been released. Check that the cutting
equipment has stopped completely and remove the
battery before you start any work on it.
Li-ion
Li-ion
!
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
!
WARNING! This machine is renowned for
its low vibration load. Overexposure to
vibration can lead to circulatory damage
or nerve damage in people who have
impaired circulation. Contact your doctor
if you experience symptoms of
overexposure to vibration. These
symptoms include numbness, loss of
feeling, tingling, pricking, pain, loss of
strength, changes in skin colour or
condition. These symptoms normally
appear in the fingers, hands or wrists.
IMPORTANT!
Only use cutting attachments with the guards we
recommend! See the chapter on
Technical data.
Refer to the instructions for the cutting attachment to
check the correct way to load the line and the correct
line diameter.
Li-ion
Li-ion