Filter
Top Products
MAINTENANCE
22
1741506
3
4
5
3
3
3
6
6
1
2
HOW TO REPLACE THE DRIVE BELT
The drive belt is of special construction and must be
replaced with original factory replacement belt avail-
able from your nearest authorized service center.
1. Remove the belt cover. See “How To Remove The
Belt Cover.”
2. (Figure 9) Remove the drive belt (1) from the idler
pulley (2).
1
2
3
4
5
3. Move the belt guide (4) away from the drive
belt (1).
4. To reduce pressure on the drive belt (1), move
the idler pulley (2) away from the drive belt (1).
Remove the drive belt (1) from between the
brake pad (3) and the roller (5).
5. Remove the old drive belt (1).
6. To install the new drive belt (1), reverse the
above steps.
7. Make sure the drive belt (1) is seated properly
on the pulleys.
8. (Figure 10) Set the belt guide (1) to 3/32”
clearance.
NOTE: When the auger control lever is en-
gaged, the belt guide (1) must be 3/32” (2 mm)
from the drive belt (2).
9. Install the belt cover. See “How To Remove
The Belt Cover.”
1
2
3/32”
Figure 8
Figure 9
Figure 10