Filter
Top Products
MAINTENANCE
English – 33
spark plug should be replaced after about a month in
operation or earlier if necessary.
CAUTION! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the piston/
cylinder. Check that the spark plug is fitted with a
suppressor.
Winter use
Running problems can occur when using the machine in
the cold and snowy conditions caused by:
• Too low engine temperature.
• Icing of the air filter and carburettor.
Special measures are therefore often required:
• Partly mask the air inlet on the starter to increase the
working temperature of the engine.
• Preheat the intake air to the carburettor by utilising the
heat from the engine.
There is a special winter kit available when using the
machine in cold and/or snowy conditions, this includes the
following:
• a special air filter cover without air intake (A)
• a cover for the filter holder (B)
• a cover for the starter housing (C)
• a special wear guard with an air duct (D) that routes
the hot air from the muffler to the carburettor
• a special air filter with a coarser mesh size (E)
Temperature 0°°
°°
C or colder:
Fit the covers for the starter housing and air filter holder
using the three screws provided as shown in the figure.
Remove the air filter and air filter cover from the machine.
Fit the air filter and air filter cover supplied with the winter
kit.
Temperature -5°°
°°
C or colder:
Dismantle the machine’s wear guard, and fit the wear
guard from the winter kit as shown in the figure. Pay
x3
ABC D
E