Husqvarna 345RX Chainsaw User Manual


 
English – 17
ASSEMBLY
Tighten the trimmer head to a torque of 35-50 Nm (3.5-5
kpm).
To dismantle, follow the instructions in the reverse order.
Fitting other guards and cutting
attachments
Fit the trimmer guard/combination guard (A) intended for use
with the trimmer head/plastic blades. Hang the trimmer
guard/combination guard (A) on the two hooks on the plate
holder (M). Bend the guard around the shaft and tighten it with
the bolt (L) on the opposite side of the shaft. Use the locking
pin (C). Place the locking pin in the groove on the screw head
and tighten. See diagram.
Fit the drive disc (B) on the output shaft.
Centre the metal cup (P) on the drive disc’s blade guide.
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
Insert the locking pin (C) in the hole to lock the shaft.
Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
To dismantle, follow the instructions in the reverse order.
Adjusting the harness and clearing
saw
Standard harness
Safety release
At the front is an easily accessible, quick release. Use this if
the engine catches fire or in any other emergency situation
that requires you to free yourself from the machine and
harness.
Spreading the load on your shoulders
A well-adjusted harness and machine makes work much
easier. Adjust the harness for the best working position.
Tension the side straps so that the weight is evenly distributed
across both shoulders.
Correct height
1 Forestry clearing
The machine should be supported in a harness when
forestry clearing so that the cutting equipment is angled
slightly forwards in relation to the ground. Adjust the
height using the strap on the harness for the support
hook.
2 Grass clearing
The machine should be supported in a harness when
grass clearing so that the cutting equipment is parallel to
the ground.
!
WARNING! When using a clearing saw it
must always be hooked securely to the
harness. Otherwise you will be unable to
control the clearing saw safely and this can
result in injury to yourself or others. Never
use a harness with a defective quick release.
B
A
M
L
H
P
L
A
M
C
H
C