Filter
Top Products
English – 25
IGNITION SYSTEM
Dismantling
1. Dismantle the starter (A) and air conductor (B).
2. Remove the spark plug and insert the piston stop (C) in the
spark plug hole. See service tools.
D
E
E
F
H
I
8. Dismantle the starter dogs by pressing out the dogs’
bearing pins using a suitable punch (ø 3 mm).
6. Fit the mandrel 502 51 94-01 on the shaft. Do not screw it
on too far, a space of 2-3 mm must remain.
7. Grip the flywheel and lift the saw. Knock the mandrel using
a hammer until the flywheel releases.
3. Loosen the cable (D) from the ignition module. Undo the
two M4 bolts (E) and lift out the ignition module (F).
4. If the ignition module is to be replaced, pull out the contact
spring from the spark plug guard and dismantle the parts.
5. Use a 13 mm spanner to undo the nut (H) and counterbal-
ance washer (I) from the flywheel.
A
B
C