Filter
Top Products
21
ENGLISH
If the HINGE WOOD is too small or has been sawn through, or if the notch and
the felling cut are mismatched, the tree is no longer under control.
As the felling cut approaches the notch, the tree should start falling, either by
itself or with the help of a WEDGE or FELLING BAR.
DAILY INSPECTION AND MAINTENANCE
CAUTION!
Always disconnect the power before cleaning or performing maintenance.
Here are a few general instructions for main-taining your chain
saw. If you are in doubt on any of these points, contact your
service dealer.
1. Inspect power cable and plug for defects.
A damaged power cable or plug must be replaced.
2. Clean ventilation openings and keep them open.
3. Clean the chain brake and ensure that it works correctly.
4. Check automatic chain lubrication.
5. Turn guide bar over at regular intervals to distribute the wear
on both sides. Check to see that the oil passage is clear.
Clean the guide bar groove.
6. Check chain tension, sharpen the cutters and ensure that
chain turns easily.
7. Check drive sprocket for abnormal wear, replacing it if necessary.
8. Remove any burrs from the edges of the guide bar