Filter
Top Products
30 - English
4. USE
3. Turn the knob to the required position. The
selected position is the marking on the knob that
aligns with the arrow on the body.
• Turn clockwise to raise the cutting height.
• Turn anticlockwise to lower the cutting height.
4. Close the cover. Ensure that the catch button
locks.
4.6 Changing the PIN code
To change the PIN code on the mower:
1. Connect the loop generator/charger charging
cable to the mower's charger contact. At most
the mower may be two metres from the working
area's boundary wire and the loop
generator/charger must be connected to the
mains supply.
2. Open the control panel cover by pressing the
STOP button. Set the main switch to the ON
position.
3. State the current PIN code, confirm by pressing
the YES button.
4. The yellow indicator lamp PIN code should now
be lit with a steady light.
5. Press and hold the number 8 key on the control
panel for 2 seconds.
6. The yellow indicator lamp PIN code should now
flash.
7. Select and enter a new four digit PIN code. All
combinations except 0000 are permitted.
8. Press the YES button.
9. Confirm the selected PIN code by re-entering the
PIN code.
3012-253
3012-758
3012-797
2 m
3012-786