Filter
Top Products
20 - English
3. INSTALLATION
Boundaries for the working area
If a high obstacle, for example a wall or fence,
borders the working area, the boundary wire should
be laid 35 cm from the obstacle. This will prevent
Automower from colliding with the obstacle and
reduce body wear.
If the working area borders against a small ditch, for
example, a flower bed or a small elevation, e.g. a low
verge (3 - 5 cm), the boundary wire should be laid
30 cm inside the working area. This prevents the
wheels from driving into the ditch or up onto the
verge.
If the working area borders against a flat path or the
like that lies level with the lawn, it is possible to allow
Automower to run a little over the path. The boundary
wire should then be laid 10 cm from the edge of the
path.
When the working area is divided by a flat slab path
that is level with the lawn, it is possible to allow
Automower to run over the path. It can be an
advantage to lay the boundary wire under the slabs.
The boundary wire can also be laid in the joint
between the slabs.
Note!
Automower must never run over a gravel path
or similar material, which can damage the blades.
If the working area borders against, for example,
pools of water the boundary wire should be
supplemented with a fence or the like. The height must
then be at least 15 cm. This will prevent Automower,
under any circumstances, coming outside of the
working area.
3012-760
35 cm
3012-761
30cm
3012-762
10
cm
3012-763