Filter
Top Products
14 - English
2. PRESENTATION
Working method
Automower automatically mows the lawn. Automower
automatically mows the lawn. When the battery is
discharged the mower stops on the lawn, and you
need to carry it to the loop generator/charger for
charging.
When Automower body hits an obstacle, the mower
reverses and selects a new direction.
Two sensors, at the front and back on Automower,
sense when the mower approaches the boundary
wire. Automower overruns the wire by up to
27 centimetres before it turns.
The
STOP
button on the top of Automower is mainly
used to stop the mower when it’s running. When the
STOP
button is pressed a cover opens, behind which
there is a control panel. The
STOP
button remains
depressed until the cover is closed again. This acts
as start inhibitor.
You start the mower via the control panel on top of
Automower. Open the control panel cover by
pressing down the
STOP
button.
A four digit PIN code must be chosen and entered
when the main switch is set in the
ON
position for the
first time. (see page 30).
The chosen PIN code must then be entered each
time the mower is started. If the mower does not start
within 20 seconds the PIN code must be re-entered
until the mower starts. Slide shut the cover to start the
mower after the PIN code has been entered.
Automower can, to save energy, enter sleep mode.
The indicator lamps on the control panel are then
turned off completely.
The sleep mode is activated 25 minutes after the
STOP
button has been pressed and then not reset to
the operating mode. Automower is then activated by
switching the main switch off and on.
The sleep mode can also be activated in the event of a
fault occurring during mowing or charging and which is
not rectified within 25 minutes. Automower is then
activated by pressing the
STOP
button.
3012-772
3012-388
3012-779