Filter
Top Products
English – 19
Driving
• The best lawns are achieved if the grass is cut often.
Mowing becomes more uniform and the grass cuttings
become more evenly distributed over the surface. The
total time consumption is not greater since it is possible to
select a higher driving speed without inferior mowing
results.
• Avoid mowing a wet lawn. The mowing results are inferior
since the wheels sink down into the soft lawn.
• Hose down the cutting unit with water underneath each
time it is used. The cutting unit should then be put in the
service position.
• When the BioClip function is used, it is very important that
the mowing interval is not too long.
Starting on a slope, manual gearbox,
Rider 11 C
1 Press down the parking brake pedal.
2 Push the throttle control to full throttle position.
3 Disengage the engine and select 1st gear.
4 Gradually release the clutch pedal.
5 When the engine starts to pull, release the parking brake.
Stop the engine
Preferably allow the engine to idle for a minute to obtain
normal working temperature before stopping it if it has been
working hard. Avoid idling the engine for long periods, as
there is a risk of carbon build-up on the spark plugs.
1 Lift up the cutting unit by pulling the lever backwards to its
locked position.
2 For Rider 11 C Pull back the throttle and move the gear
shift lever to the neutral position ”N”, without pressing in
the reversing lock button. Turn the ignition key to the
”STOP”.
For Rider 13 C, Rider 16 AWD and Rider 16 C Pull back
the throttle and turn the ignition key to the ”STOP”
position.
3 When the Rider is at a standstill, press down the parking
brake and push in the locking button.
!
WARNING! Do not use the machine on
ground that slopes more than 10
°°
°°
..
..
Mow
slopes upwards and downwards, never
across. Avoid sudden changes in direction.