Filter
Top Products
English – 25
Maintenance
Replacing the light bulbs
For information about the bulb type, see Technical Data.
1 Loosen the lock nut and remove the Allen bolt. Remove
the steering wheel.
2 Unscrew the two screws holding the cover on the power
servo housing. One screw on each side.
3 Press in the parking lock button and lift the cover over the
steering column.
4 Carefully remove the lamp insert from its two brackets.
5 Disconnect the cables from the bulbs.
6 Lift out the bulbs from the insert.
7 Insert the new bulbs. Make sure you use your thumb to
support the front.
8 Refit the cables, lamp insert and the cover on the power
servo housing.
9 Replace the steering wheel.
Main fuse
The main fuse is placed in a detachable holder under the
battery case’s cover, in front of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.