Filter
Top Products
English – 33
MAINTENANCE
WARNING!
Wear gloves to protect your
hands when working with the
blades.
5. Ensure the blades are positioned as set out in
the diagram, at 90 degrees to each other,
otherwise the belt must be adjusted. When the
blade bearings are loose the belt can be moved
around to the next tooth.
Tighten the nuts enough so that the bearings
rest against the cutting hood but still can be
moved.
Tension the belt by turning the eccentric adjuster
on top of the cutting hood. Tighten the nut.
Tighten all nuts on the blade bearings.
6. When the belt can be moved 8 mm (5/16")
inwards using a force of 7 N (1.5 lb) the belt is
adjusted correctly.
7. Fit the protective cover over the belts and
replace the parall strut.
IMPORTANT INFORMATION
The blades on a BioClip unit should be
set at 90 degrees to each other. In all
other cases the blades can collide and
cause serious damage to the cutting unit.
Belt replacement on the Combi 103, 112 cutting
unit
On these cutting units with “collision-proof” blades,
the blades are driven by one V-belt. Do as follows to
change the V-belt:
1. Remove the cutting unit.
2. Undo the bolt on the lift strut and the two screws
on the cover. Lift the cover off the cutting unit.
3. Loosen the spring (4) that tensions the V-belt
and pry off the belt.
Simply reverse the procedure to fit the new belt.