Filter
Top Products
30 – English
6. Move the support wheels to their parking
position.
7. Fit the front cover.
8. Secure the collet spring.
WARNING!
Wear protective glasses when
removing the cutting unit. The
collet spring which tensions up
the belt can go off and cause
personal injury.
Removing the cutting unit
2
3
1
MAINTENANCE
1
2
8
9
Installing BioClip 90
In order to install BioClip 90 the drive belt support
wheel must first be removed.
1. Release the collet spring, see fig above.
2. Remove the locking pin (1) that is located next to
the support wheel.
3. Screw off the nut and washer (2) under the
centre of the support wheel. Remove the screw
and support wheel.
4. Fit the cutting unit according to the instructions
above.
1. Carry out points 1-9 to put the cutting unit in the
service position, see “Service position for the
cutting unit”.
2. Remove the bolt (3) and lift off the cutting unit.