Filter
Top Products
English – 49
LUBRICATION
Check the transmission’s oil level
1. Remove the transmission cover. Loosen both
screws (one on each side) and lift off the trans-
mission cover.
2. Check that there is oil in the transmission’s oil
tank. Fill if necessary with engine oil.
Rider 155: SAE 10W/30 (class SF–CC).
Rider 155 AWD: SAE 10W/40 (class SF–CC).
6008-039H
6008-240H
8009-466
Change of oil filter
Replace oil filter every 200 operating hours. Drain
oil first using the plug on the filter base. Remove
the old filter using an oil filter tool. Lightly coat
rubber gasket with new oil, then install filter by
turning it to the right until hand tight. Tighten the
filter an additional 1/2 turn. Check that the drain
plug is reinstalled before starting the engine.
Start engine and check for leakage.
6008-039H
Rider 155 AWD
The oil should be changed by an authorised service
workshop, and is described in the Workshop
Manual.
The filter is replaced at the same time as changing
the oil.
Work on the system entails particular demands on
cleanliness and the system must be vented before
the machine is used.