Filter
Top Products
26
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Unit will not stop when trigger is
released (contd)
Wand is malfunctioning Test both wands to ensure that one is not
malfunctioning.
Gun is not operating properly Remove Wand from the Gun and squeeze trigger to
ensure that the water is coming out of the front of the
Gun at a rate equal to the Garden Hose.
Wand - Attaching
To attach the Wand apply some moderate downward
pressure force on the Wand (In the direction of the
trigger) while simultaneously twisting the wand a 1/4
of a turn counterclockwise. (It may help if you set the
gun vertically on a flat surface with the wand pointing
upwards). The two tabs on the end of the Wand must
slide all the way in before the Wand will twist and
lock. If this does not work remove the o-ring from the
end of the wand and attach it without the o-ring. If the
wand attaches, you will need to replace the o-ring.
Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Wand - Removing Release the back pressure in the Gun/Hose.
Remove the Garden Hose from the unit and
squeeze the trigger of the Gun. Apply some
moderate downward pressure force on the
Wand (In the direction of the trigger) while
simultaneously twisting the wand a 1/4 of
a turn clockwise. (It may help if you set the
gun vertically on a flat surface with the Wand
pointing upwards). For additional assistance
you can email us at:
customerservice@huskypowerwasher.com.
The green “Ready” light is not
illuminated.
NOTE: The green “Ready” light
should illuminate when the machine
is plugged in and the ON button is
depressed.
No power Reset GFCI according to the procedure in
Owner’s Manual section 3.3. Check that the
circuit is dedicated and rated at 15 amps or
greater.
The yellow “Medium” light will
not illuminate.
NOTE: The yellow “Medium” light
will only illuminate when using the
turbo wand or the Click-N-Clean
TM
wand set to the “Medium Fan Spray”
or “Detergent Spray” position and
the gun trigger is depressed motor is
running and water is spraying from
the nozzle.
The Click-N-Clean
TM
is not set
to the proper position.
Make sure that the Click-N-Clean
TM
wand is set
to the “Medium Fan Spray” or “Detergent Spray”
position.
Use of improper extension
cord.
Use proper extension cord as recommended in
Owner’s Manual.
Clogged nozzle Clean nozzle as instructed in Owner’s Manual
section 5.2.
The blue “High” light will not
illuminate.
NOTE: The blue “High” light will
only illuminate when the Click-N-
Clean
TM
wand is set to the “High
Pressure Fan Spray” position
and the gun trigger is depressed,
motor is running and water is
spraying from the nozzle.
Faucet not fully open or unit is
not receiving a full volume of
water.
Ensure that the faucet is fully open.
Check garden hose connection and ensure that
the garden hose meets criteria as described in the
Owner’s Manual.
Screen filter clogged. Clean the screen filter as instructed in Owner’s
Manual section 5.4.