Hunter Fan TYPE 3 Outdoor Ceiling Fan User Manual


  Open as PDF
of 16
 
8
42659-01•02/19/08•HunterFanCompany
CAUTION: e remote control device complies with part 15 of the FCC rules.
ChangesormodicationsnotexpresslyapprovedbyHunterFanCompanycouldvoid
your authority to operate this equipment.
Operationissubjecttothefollowingtwoconditions:
1. is device may not cause harmful interference.
2. is device must accept any interference received, including interference that may
cause undesired operation.
Note:Usewithafanthatincorporatesanairgapswitch(normalon-owallswitch).
WARNING:Maximumfanloadis1Amp;maximumlampis19Watts.Donotuse
any speed control with this product.
Youmustnowsetthejumpersintheremotetransmitterandreceiver
so that they match.
5-1. Changethepositionofthejumpersinthetransmitterandthe
receiver.Besurethepositionofthejumperinthetransmitter
matchesthepositionofthejumperinthereceiver.Iftheydon’t
match, the controller will not function. For instructions on how to
setthejumpers,readtheboxbelow.
5-2. Install the included 12-volt battery into the transmitter.
Setting Jumpers
When two or more fans are located near each other, you may desire to
have the receiver/transmitter for each fan set to a different code, so that
the operation of one fan does not affect the operation of the other fans.
Inthetransmitteryoucanaccessthejumpersfromthebattery
compartment.ejumpersareverysmall.Youcanmovethemmost
easily using a small pair of pliers or tweezers. IMPORTANT! Before
youchangeajumper,makesurethebatteryisnotconnectedtothe
transmitter.
4321
4321
4321
4321
4 = off (apagado)
3 = on (encendido)
2 = on (encendido)
1 = on (encendido)
4 = off (apagado)
3 = on (encendido)
2 = off (apagado)
1 = on (encendido)
Example Jumpers Settings
Receiver1 Receiver2
Transmitter 2Transmitter 1
4321
4321
4321
4321
4 = off (apagado)
3 = on (encendido)
2 = on (encendido)
1 = on (encendido)
4 = off (apagado)
3 = on (encendido)
2 =
off (apagado)
1 = on (encendido)
5 • Setting the Remote Transmitter and Receiver
 previous next