Filter
Top Products
Step 9: Operation of Fan
A.
Turn electrical service on at main panel.
B. Switch operates in this sequence: “High,” “Medium,”
“Low,” “Off.” Pull chain slowly to operate. Also, release the
chain slowly so as to prevent chain from flying up into blades,
possibly resulting in damage to blades, or pull chain. The break-
away connector is designed to separate from the chain at a pre-
determined force. If this separation occurs, simply reinsert the
connector. It can be reused again and again. See Figure 9.
C. Motor is electrically reversible. When first operating fan,
determine direction of air flow. If you wish to change direction,
switch fan off and allow to stop. Slide reversing switch to the
opposite position and switch fan back on. See Figure 9.
Speed Control
As an option, a wall mounted speed control switch is available
from your Hunter dealer.
FIGURE 9
©1995 HUNTER FAN CO.
TM
FORM NO. 41110-01 6/95 - 4-
®
HUNTER FAN COMPANY
2500 FRISCO AVENUE
MEMPHIS, TN 38114
TROUBLESHOOTING GUIDE
PROBLEM PROBABLE CAUSE SOLUTION
1. Nothing happens;
fan does not move.*
2. Noisy operation.
3. Excessive wobbling.
1. Power turned “off” or fuse blown.
2. Loose wire connections or wrong
connections.
3. Motor reversing switch not engaged.
4. Pull chain switch not “on.”
5. Rubber shipping blocks not removed.
1. Blade brackets loosely screwed to motor.
2. Blade screwed loosely to blade bracket.
3. Blade cracked.
4. Non-approved speed control being used.
1. Blade brackets not attached at proper locations.
2. Unbalanced blades.
3. Fan too close to vaulted ceiling.
4. Loose blades or blade brackets.
5. Fan not secure on hanger assembly.
1. Turn power “on” or replace fuse.
2. Loosen canopy. Check all connections (turn
power “off” while checking).
3. Push switch firmly to one side or the other.
4. Pull chain switch.
5. Remove shipping blocks.
1. Tighten screws until snug.
2. Tighten screws.
3. Replace all blades.
4. Change to approved speed control.
1. Carefully review Step 8.
2. Use blade balancing kit. (See Step 8C.)
3. Lower or move fan.
4. Tighten all screws.
5. Turn power off. Support fan very carefully.
Loosen canopy and hang correctly.
When switching from medium to low speed, you may notice some fan wobble. When fan speed stabilizes at low speed, wobble will disappear.
*NOTE: If blades will not turn by hand, contact your nearest service representative.
PULL CHAIN
SWITCH
BREAKAWAY
CONNECTOR
PURCHASED ACCESSORY
CHAIN (IF DESIRED)
REVERSING
SWITCH
BLADE MOUNTING
SCREWS
NOTE: MAKE CERTAIN
ALL SCREWS ARE
TIGHT.